Hi Everyone and welcome to another Deal With It video tutorial, this time sharing how I deal with all the metal tabs and scraps that I accumulate on my work surface while cutting apart a new die set! Be sure to watch the short video below to see how to easily clean them all off of your work surface, without injuring yourself!!
I hope you all enjoyed this short little video tutorial and found it helpful! If you are looking for the magnet I used, I do have it linked below (Affiliate Link is used at no additional cost to you), but, if I’m being 100 % honest it would be much more economical and cheaper to try a magnet from your fridge or pick one up at your local hardware store!
Thank you all so much for stopping by and spending a bit of time with me today! Until next time, Happy Crafting!!